H-REAP Design and Deployment Guide – Cisco Learning Read more about controller, lwapp, configuration, wireless, configured and wlans. HReap Design and Deployment Guide: /products_tech_noteashtml Configuring Hybrid REAP. 27, 24, , 2/8/, Wireless LAN IPv6 Client Deployment Guide New! 55, 14, , 6/29/, H-Reap Design and Deployment Guide.
|Published (Last):||12 August 2017|
|PDF File Size:||4.23 Mb|
|ePub File Size:||13.66 Mb|
|Price:||Free* [*Free Regsitration Required]|
Local controller at guids site is primary controller for desibn APs at remote site and centrally located controller is secondary controller for the APs at remote site. Anonymous November 15, at 6: Anonymous November 16, at 9: Should we be expecting seamless fail-over in this scenario? Anonymous February 7, at Kristjan, No configuration is replicated between desigm.
Anonymous June 24, at 2: Not exactly all of the changes make it into the release notes, but most of the major ones do. That way it’s easier to remain on top of the changes in an incremental fashion, rather than trying to figure out what changed from a year ago and three releases ago: Administrators should design a solution around these requirements as best as possible. Newer Post Older Post Home.
Additionally, feature limitations when using this mode of operation need to be clearly understood by network administrators prior to evaluating and deploying an H-REAP solution. Andrew vonNagy November 17, at In this post, I will build on those basic fundamentals and provide more depth on the recommended deployment guidelines if you’re thinking about deploying H-REAP for remote sites.
What is H-REAP mode?
I must admit though, I prefer your summaries to the matrix and release notes. Hi Andrew, Deploymfnt, I missed that post Steve Williams June 27, at 7: So fail-over is not seamless. Anonymous March 16, at Motorola is trying to get their with their WiNG product but will take some time. Am I right about that? Aerohive has an advantage because they were able to develop their product without existing product roadmaps and feature sets to support and upgrade along the way.
And we are noticing the loop in to the network? Hi, It is true that the cisco can supports dynamic vlan assignment with hreap configured in local-switching mode?
Here is a link from cisco. I’ll be sure to post my thoughts on their product.
This is still an open feature gap. We have deployed H-reap with two centralized controllers at two different locations.
Posted by Andrew von Nagy at 9: I can be reached at cbagley nmmu. Andrew vonNagy December 13, at 6: Searching high and low for this but could not still get my hands on one.
Revolution Wi-Fi: H-REAP Deployment Guidelines and Feature Limitations
The AP expects a response from the controller within 2 seconds, otherwise it sends up to 5 more hearbeat packets at 1 sec. Xirrus does something similar, with a controller in every AP and coordination among multiple APs. In versions prior to 7. Do we need to all H-reap groups on both controllers even there are no APs on other controller in that group?
KD July 2, at Kristjan December 5, at Same mobility group name is configured on the herap controllers and we are following HREAP deployment requirements. In addition to feature limitations that apply to all H-REAP operational states, the following limitations delpoyment apply when the AP goes into standalone mode after losing connection to the controller.