H-REAP Design and Deployment Guide – Cisco Learning Read more about controller, lwapp, configuration, wireless, configured and wlans. HReap Design and Deployment Guide: /products_tech_noteashtml Configuring Hybrid REAP. 27, 24, , 2/8/, Wireless LAN IPv6 Client Deployment Guide New! 55, 14, , 6/29/, H-Reap Design and Deployment Guide.
|Published (Last):||6 August 2010|
|PDF File Size:||19.86 Mb|
|ePub File Size:||7.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
I can be reached at samuel. Troy Martin June 10, at 5: I think we’ll see some big announcements from those two in 1H Administrators should design a solution around these requirements as best as possible. I’ll be sure to post my thoughts on their product.
We have tried to do load sharing by dividing groups to both controller. Because it should already know as it is configured this way before its primary WLC goes offline for some reason. Xirrus does something similar, with a controller in every AP and coordination among multiple APs.
Could you kindly point me to a Cisco hrepa that specifies the same pls?. First, several guidelines are recommended for successful deployment. Cheslin June 28, at 8: I must admit though, I prefer your summaries to the matrix and release notes.
Anonymous June 24, at 2: Anonymous November 16, at 9: Kristjan December 5, at Anonymous November 15, at 6: Hi Andrew, Thanks for guidr post. Hi Andrew, Sorry, I missed that post Steve Williams June 27, at 7: Local controller at remote site is primary controller for the APs at remote site and centrally located controller is secondary controller for the APs at remote site.
What is H-REAP mode?
Are you sure it is neccesary to add the APs manually to the secondary controller? Troy Martin June 15, at Would you able to advise me,by having APs in one group, what effects it would have on deploymenf
You would have to manually configure the information on both. Andrew vonNagy November 17, at But it’s still fairly manual. Look for Cisco and Aruba to make some headway in this area in as well. Seems like a refreshing approach.
What is H-REAP mode?
Anonymous March guixe, at 1: The AP expects a response from the controller within 2 seconds, otherwise it sends up to 5 more hearbeat packets at 1 sec. And we are noticing the loop in to the network?
This reployment still an open feature gap. Hi, It is true that the cisco can supports dynamic vlan assignment with hreap configured in local-switching mode?
Same mobility group name is configured on the both controllers and we are following HREAP deployment requirements. It does seem like a deppoyment approach, and I am curious to see how their system scales to large environments.
Andrew vonNagy June 13, at Should we be expecting seamless fail-over in this scenario?